The Diver 6 pumps are very easy to install and they don’t require any configuration. In the product manual available on our website or in our DNA software, there is the procedure for using the pump in manual or automatic mode.
Insert the plug of the power cable into a suitable power socket.
Automatic operation:
The floating switch starts and stops the pump automatically. The water level that prompts the starting and stopping of the pump can be adjusted by changing the length of cable of the float between the holder and the float.
N.B. The length of the float cable must never be shorter than 10 cm.
Manual operation:
a) The floating switch must be lifted in order to start pumps with a float.
b) For pumps without a float, insert the plug.
The voltage and frequency specified on the pump’s nameplate coincide with those of the available power
supply;
• there are no signs of damage to the pump or its power cord;
• the electric connection is made in a dry place, protected against any risk of flooding;
• the electric system is complete with a residual current circuit-breaker (I ∆ ≤ 30 mA) and an efficient earthing connection;
